Ontario requires white reflective material on the front forks and red reflective material at least 250 mm long by 25 mm wide on the rear of a bicycle or power-assisted bicycle (e-bike).

Lighting is a separate obligation: a white or amber front lamp and a red rear lamp or reflector are required from one-half hour before sunset to one-half hour after sunrise, or whenever visibility is under 150 m.

Regulatory summary

Sources

• City of Toronto, "Cycling & the Law", quoting Highway Traffic Act s.62(17) — toronto.ca
• California Legislative Information, Vehicle Code s.21201 — leginfo.legislature.ca.gov

What this page does and does not claim

The Act sets reflective-material dimensions and timing rules for the rider and the vehicle. It is not a product-certification scheme, and no body certifies reflective kits under this section. Only Ontario and the California example are cited here because those are the requirements confirmed against the source text — other provinces and states set their own rules, so check the requirement where you ride.

Ontario e-bike PAB label kit

Order manufacturer-authorized data-label reproductions or clearly separate dealer, rental-fleet, service, recovery and asset labels. This product does not make a bicycle qualify as a power-assisted bicycle and is not government approval or manufacturer certification. It is an identification label — it is not the rider-installed reflective material described above.

Choose the label finish

• White vinyl: high contrast on dark or coloured frames.
• Black vinyl: a lower-contrast visual fit on light, silver, grey or white frames.
• Reflective white: a high-visibility option for fleet, rental and service identification; it is not presented as an Ontario requirement.

Choose the pack size

Select a 2-label kit, 5-pack, 10-pack or 25-pack. The finished label is approximately 3 inches wide by 1.75 inches high (76 mm by 44 mm); this is a product dimension, not a universal Ontario legal minimum.

Information required for production

For a manufacturer-context label, provide the manufacturer or authorized source, exact wording or artwork, model or serial scope, dimensions and approval contact. For a separate fleet or asset label, provide the fleet wording, numbering, contact or QR destination, preferred size and placement.

Proof before production

We provide a proof for text, layout, finish and quantity review. A printed label cannot correct an over-powered, over-speed, overweight, pedal-less or otherwise non-qualifying vehicle. Confirm the actual bicycle against the current Ontario requirements and manufacturer records.

Frequently Asked Questions

What reflective material does Ontario require on an e-bike?
White reflective material on the front forks and red reflective material of at least 250 mm by 25 mm on the rear, under Highway Traffic Act s.62(17). The same section covers bicycles and motor-assisted bicycles.

Does this label kit satisfy the reflector requirement?
No. This is an identification label. The reflective material described in s.62(17) is separate rider-installed material on the forks and rear of the bicycle.

Is the reflective white finish required by Ontario?
No. Reflective white is offered as a visibility option for dealer, rental and service identification. It is not presented as an Ontario requirement.

Do the same rules apply outside Ontario?
No. Each province and state sets its own requirements. California, for example, specifies a rear reflector visible at 500 ft plus pedal and side reflectors under Vehicle Code s.21201(d).

Does buying this kit make a bicycle a power-assisted bicycle?
No. A printed label cannot change the motor output, speed, weight or pedals of the actual vehicle.